Depa DH50-FA - Page 3

3
DEPA
®
Air Operated Diaphragm Pumps
for partly completed machinery
according to the machinery directive 2006/42/EC
The manufacturer
Crane Process Flow Technologies GmbH,
Heerdter Lohweg 63-71, 40549 Düsseldorf, www.depapumps.com
declares that with the series production pulsation dampers
Designation:
DEPA compressed air diaphragm pumps without air control
Series:
DJ/DH*, PD, PH
* DHxx-FA in custom design with control block
for external air control.
Serial number: seeidenticationplate
thefollowingbasicrequirementsasspeciedinannexIoftheabovedirectivehavebeenappliedand
complied with:
General principles No. 1
Nr. 1.1, 1.3, 1.5, 1.6; 1.7, 2.1, 3.4, 3.6, 4.1 und 4.2
Commissioningisprohibiteduntilithasbeendeterminedthatthemachineintowhichtheabovespecied
machine shall be incorporated meets the machinery directive 2006/42/EC.
Pay attention to the installation instructions in Chapter 3 and 7.2 of these operating instructions.
ThespecialtechnicaldocumentswerepreparedincompliancewithannexVIIpartBofthedirective.The
previously mentioned special technical documents will be made available to the competent authority by
mail, if this should be necessary.
EC directive:
Machinery directive 2006/42/EC
Harmonized standards: DIN EN ISO 12100:2011-03,
DIN EN 809:2012-10
Mr. Ralf Rennwanz is authorized to compile the technical documents.
Crane Process Flow Technologies GmbH
Heerdter Lohweg 63-71
40549 Düsseldorf
Place / date: Düsseldorf, 08/07/2015
Signature of manufacturer:
Information on signatory:
Hans-Dieter Ptak, Managing Director
Declaration of Incorporation