Depa DH50-FA - Page 4

4
DEPA
®
Air Operated Diaphragm Pumps
in accordance with directive 2014/34/EU for equipment intended for use
inpotentiallyexplosiveatmospheres
The manufacturer: Crane Process Flow Technologies GmbH, Heerdter Lohweg 63-
71, D-40549 Düsseldorf, www.depapumps.com
declares that the pump units manufactured in series production
Designation
: DEPA Air Operated Diaphragm Pumps and
DEPA Active Pulsation Dampeners
Series: DL, DH, DF, DZ, DJ, DP, DBX* and PD, PH
* High pressure pump without booster
Assessment method
: EquipmentgroupII,category2GD,explosiongroupIIBTx
Pump size: 15, 25, 40, 50, 80
Casing material: FA,CA,SA,SF-,SLV,SUV,UEV,CX,SX,PL,TL,SS,SFS,TPL,
HS, HX
Diaphragm materials: EPDM, FKM**, NBR, EPDM grey**, NRS, PTFE compound,
PTFE, S4**
** not for size 80
Valve ball materials
: EPDM, NBR, PTFE, NRS, 316L, FKM, EPDM grey
Accessories: Start-up valve, service unit, clamping adapter, mobile unit vehicle,
uidisationsystem,balllifter,needlevalve,levelcontrol,collecting
pan, suction lance, high-performance silencer, suction and pres-
sure hose
Installed electrical components
: Specicmanufacturer’sdeclarationsofconformityaresupplied
with all of the electrical units
in the design delivered by us, are in compliance with the following applicable regulations:
EU Directive
:: Directive 2014/34/EU for equipment authorised for use in poten-
tiallyexplosiveenvironments.
Harmonised standards: DIN EN 1127-1:2008-02 (for pump and pulsation dampeners)
EN 13463-1:2009-07 (for accessories)
EN 13463-5:2011-10 (for accessories)
Mr. Ralf Rennwanz is authorised to compile the technical documents.
Crane Process Flow Technologies GmbH
Heerdter Lohweg 63-71
40549 Düsseldorf
Place / date: Düsseldorf, Germany, 17/06/2017
Signature of manufacturer:
Information on signatory
: Hans-Dieter Ptak, Managing Director
EU Declaration of Conformity
ATEX
II 2GD IIB Tx