31
6.3.10. SHIFTING MOTORIZED CYLINDER TO ENROLLING NEW CONTROLLER MODE
- Touch to device with your palm to wake it up. Two arrows will appear on display. Touch “Button #2”. ADMIN will be shown.
- Put one of the master fingers onto the reader. First “OK” and then “LEARN” will be shown.
- Touch the “Button #2" till “R.LEARN” appears and touch “Button #1" when “R.LEARN” is on display.
- “OK” will be displayed. The motorized cylinder will shift to enrolling new controller mode with a long and a short warning
tone. Schematic representation of operation is as follows:
DESi
OK
OK
ADMIN R.LEARN
For auto-locking module;
take the magnet closer to
triangle sign and wait
indicator is lit.
For keypad;
wake it up and touch the
locking button.
For remote controller;
press and hold any
button.
DESi
For home automation interface;
power up the device and short-circuit and then open-circuit yellow and black cables.
3-12 V
DC
For other controllers,
send locking or unlocking
signal via related
controller.
For enrolling a new
mobile phone, please
check next page.
Just after the short warning tone;
To Next Page
Loading...