What to do if the door of my Despatch Oven will not stay closed?
If the door of your Despatch Oven won't stay closed, it's likely due to inadequate latch tension. Ensure the latch strike is contacting the center of the latch. Adjust the mounting angle to center as required. Increase latch tension by turning screws on the end of the latch clockwise. Adjust in even increments on all four screws to keep door pull even.
Why is my Despatch Oven making a grinding noise?
A grinding noise in a Despatch Oven suggests the fan wheel has shifted or fallen. Inspect the wheel and reposition it within 0.25” from the top of the housing.
What to do if the door of my Despatch Oven closes into top or bottom latch only?
If the door of your Despatch Oven closes into only the top or bottom latch, it's likely due to uneven latch tension adjustment. Ensure that the latch strike is contacting the center of the latch. Adjust mounting angle as required. Adjust door for even top and bottom latch tension by turning screws on ends of latch. Clockwise increases tension on latch. Counterclockwise decreases tension.
Essential information for safe and effective oven operation.
Time to temp, recovery, uniformity, and control stability.
General safety guidelines and warnings for oven operation.
Steps for safely de-energizing equipment before maintenance.
Guidance on connecting the oven to the electrical supply.
Detailed steps for powering on and starting the oven.
Procedure for adjusting the oven's temperature setpoint.
Procedure to set the high limit temperature setpoint.
Table of common problems, causes, and suggested solutions.
Steps to check and verify DES2000 control instrument parameters.
Procedure for resetting the high limit instrument.
General| Heating Zones | 1 |
|---|---|
| Control System | Digital control |
| Interior Dimensions | 18 x 18 x 18 inches |
| Construction | Stainless steel interior |
| Insulation | Mineral wool insulation |
| Temperature Range | 15 °C above ambient to 260 °C (500 °F) |
To Next Page