LBB Series Oven Owner’s Manual ASSEMBLY & SETUP
Version 20 25
4.2.2. Set-up Procedure
1. Place oven on bench top or optional cabinet base.
a. Ensure a minimum of six (6) inches (15.3 cm) clearance in the rear of oven to provide
proper ventilation. The oven may be placed next to another cabinet, or next to another
oven, with three (3) inch (7.6 cm) clearance (the doors will still open).
b. Ensure oven is level and plumb for proper heat distribution and operation of all
mechanical components.
2. Identify correct power source indicated on the specification nameplate.
3. Plug or hardwire oven directly to the electric supply.
4.2.3. Wiring & Power Connections
Read the Model LBB nameplate (top of oven or top of control
area under the door) for proper power requirements before
proceeding with wiring and power connections (Figure 7).
Danger!
All grounding and safety equipment must be in compliance with
applicable codes, ordinances and accepted safe practices.
Warning!
All grounding and safety equipment must be in compliance with
applicable codes, ordinances and accepted safe practices.
Warning!
Do not use the oven in wet, corrosive or explosive atmospheres
unless this oven is specifically designed for a special
atmosphere.
To Next Page
Loading...
