Dettson Chinook C30-M-V - User Manual

2016-09-19 X40225 Rev.O
IMPORTANT: The furnace must be installed with the Modulating Touch-
Screen Thermostat R02P030 (#1F95M). If the furnace is to be installed with the modulating cooling option, use
the Communicating Thermostat R02P029 (#1F991292).
ATTENTION: Do not tamper with the unit or its controls. Call a qualified service technician.
INSTALLER / SERVICE TECHNICIAN: Use the information in this manual for the installation / servicing of the furnace and
keep the document near the unit for future reference.
Gas furnaces manufactured on or after May 1, 2017 are not permitted to be used in Canada for heating of buildings or
structures under construction.
These instructions must be read and understood completely before attempting installation.
HOMEOWNER: PLEASE Keep this manual near the furnace for future reference.
Manufactured by:
Industries Dettson Inc.
Sherbrooke (Québec) Canada
www.dettson.ca

Summary

Dettson Installation Guide and Owners Manual

Safety Regulations

Safety Labeling and Warning Signs

Explains DANGER, WARNING, and NOTE symbols and their meanings.

Introduction to Furnace Systems

Codes and Standards

Lists national and local codes for installation.

Safety Codes and Standards

References safety codes like NFGC and CAN/CSA.

General Installation Standards

Cites standards for general installation practices.

Combustion and Air Ventilation Codes

Specifies codes for air supply for combustion.

Gas Piping and Pressure Testing

Requirements for gas piping installation and testing.

Electrical Connections Standards

References electrical codes for wiring.

Alizé Cooling Unit Integration

Thermostat Usage with Alizé System

Details on using the communicating thermostat with the Alizé system.

Furnace Installation Procedures

Upflow Orientation Installation

Instructions for furnace installation in upflow position.

Right Side Condensate Drain Trap Connection

Steps for connecting the drain trap on the right side.

Left Side Condensate Drain Trap Connection

Steps for connecting the drain trap on the left side.

Down Flow Orientation Installation

Instructions for furnace installation in downflow position.

Down Flow Condensate Drain Trap Connection

Steps for connecting the drain trap in downflow orientation.

Horizontal Right Orientation Installation

Instructions for furnace installation in horizontal right orientation.

Horizontal Right Condensate Drain Connection

Horizontal Left Orientation Installation

Instructions for furnace installation in horizontal left orientation.

Horizontal Left Condensate Drain Connection

Duct Installation Guidelines

General Duct Requirements

Standards for designing and sizing duct systems.

Return Air Connections

Supply Air Duct Guidelines

Gas Piping Installation

General Gas Piping Requirements

Requirements for gas piping installation according to codes.

Gas Valve and Propane Conversion

Procedures for converting gas type and using gas valve.

Electrical Connections

120 V Wiring Guidelines

Guidelines for connecting the 120V power supply.

24 V Wiring Instructions

Thermostat Compatibility

Information on compatible thermostats for the system.

Venting and Combustion Air Piping

Direct Vent (2 Pipe) Applications

Non-Direct Vent (1 Pipe) Applications

Connecting Vent and Combustion Air to Furnace

Combustion Air Piping Installation

Installation of the combustion air pipe.

Exhaust Vent Piping Installation

Installation of the exhaust vent pipe.

Vent and Combustion Air Pipe Sizing

Determining the correct pipe size and length.

Vent Termination Installation

Procedures for installing vent termination components.

Concentric Vent Termination

Two Pipe Vent Termination

Sidewall Vent Termination

Start Up, Adjustment, and Safety Check

Starting the Furnace

Procedures for starting the furnace.

Lighting Instructions

Setup Switch Configuration

Configuring the furnace control setup switches.

Fault Code Reset Procedure

Sequence of Operation

Detailed steps of furnace operation cycles.

Heating Cycle Initiation

Heating Cycle Response

Setting Input Rate

Thermostat Information and Connections

Non-Communicating Modulating Thermostats

Information on compatible modulating thermostats.

24 VAC Thermostat Input (J4 & J6)

Stepper Gas Valve Control

Memory Card Information

Details on the furnace memory card and shared data.

Dipswitch Settings

Configuration settings using dipswitches.

S1: Heat Air Flow Adjustment

S3-1 & S3-2: Cooling Airflow Select

S3-3 & S3-4: Cooling;Heat Pump Airflow Adjustment

S4: Heat Rise Adjustment

S5: Cooling Settings

Users Information Manual

Lighting the Furnace

Turning Off Gas Supply

Furnace Maintenance

Routine maintenance tasks for optimal performance.

Combustion and Ventilation Air

Ensuring adequate air supply for safe operation.

Filter Cleaning and Replacement

Condensate System Maintenance

Fault Code Buffer Management

Clearing Diagnostic Fault Codes

Active Fault Codes Interpretation

Display and interpretation of active fault codes.

Dettson Chinook C30-M-V Specifications

General

Model	Chinook C30-M-V
Heating Capacity	30, 000 BTU/h
Blower Type	Variable Speed
Blower Motor	ECM
Weight	110 lbs
Efficiency	95%
Fuel Type	Natural Gas