Dettson Chinook C45-M-V - User Manual

2016-09-19 X40225 Rev.O
IMPORTANT: The furnace must be installed with the Modulating Touch-
Screen Thermostat R02P030 (#1F95M). If the furnace is to be installed with the modulating cooling option, use
the Communicating Thermostat R02P029 (#1F991292).
ATTENTION: Do not tamper with the unit or its controls. Call a qualified service technician.
INSTALLER / SERVICE TECHNICIAN: Use the information in this manual for the installation / servicing of the furnace and
keep the document near the unit for future reference.
Gas furnaces manufactured on or after May 1, 2017 are not permitted to be used in Canada for heating of buildings or
structures under construction.
These instructions must be read and understood completely before attempting installation.
HOMEOWNER: PLEASE Keep this manual near the furnace for future reference.
Manufactured by:
Industries Dettson Inc.
Sherbrooke (Québec) Canada
www.dettson.ca

Summary

Safety Regulation

Safety labeling and warning signs

Explains DANGER and WARNING labels for hazard severity.

Important information

Emphasizes consequences of non-compliance and homeowner responsibility.

Detection systems

Recommends CO and smoke detectors for safety and furnace safety devices.

Installation

Upflow orientation

Down flow orientation

Horizontal right orientation

Horizontal left orientation

Duct Installation

General requirements

Standards and guidelines for designing and installing duct systems.

Return air connections

Supply air ducts

Gas Piping

General

Requirements for gas piping installation according to codes.

Gas valve and propane conversion kit

Instructions for converting the furnace from natural to propane gas.

Electrical Connections

120 V wiring

Requirements for connecting the 120V power supply to the furnace.

24 V wiring

Thermostats

Information on selecting and wiring compatible thermostats.

Venting and Combustion Air Piping

Introduction

Connecting to furnace

Combustion air piping

Exhaust vent piping

Size of the vent and combustion air pipes

Installing the vent termination

Procedures for installing concentric, two-pipe, and sidewall vent terminations.

Start Up, Adjustment and Safety Check

To start the furnace

Steps for initiating furnace operation and lighting procedures.

Unit operation hazard

Warnings about hazards during furnace operation and safety controls.

Setup switches

How to configure furnace settings using dipswitches.

Fault code reset

Sequence of operation

Thermostat

Non-communicating modulating thermostats

24 VAC thermostat (TSTAT) INPUT (J4 & J6)

Dipswitch settings for thermostat operation

Users Information Manual

Operating and Lighting Your Furnace

Basic operation, lighting procedures, and safety checks for the furnace.

Furnace Shutdown and Gas Shutoff

Routine Furnace Maintenance

Routine maintenance steps for efficient and safe furnace operation.

Safety Controls and Displays

Fault Code Resolution

Procedures for clearing faults and understanding active fault codes.

Dettson Chinook C45-M-V Specifications

General

Model	Chinook C45-M-V
Type	Gas Furnace
Heating Capacity	45, 000 BTU/h
Fuel Type	Natural Gas or Propane
Efficiency	95% AFUE
Blower Type	Variable Speed
Motor Type	ECM
Blower Motor	Variable Speed ECM
Ignition Type	Hot Surface Ignition
Vent Type	Direct Vent
Warranty	10-Year Limited Warranty