13
Parts Replacement/Maintenance
Chart 1 – Air Caps
PART No. FOR
AIR CAP
TECHNOLOGY
MARKING ON
AIR CAP
RECOMMENDED
INLET PRESSURE
(bar)
AIR FLOW
(L/min) @ 2
bar
PROLT-GTE10-1314 LVMP TE10 0.2 270
PROLT-GTE20-1314 LVMP TE20 0.2 380
PROLT-GHV30-1314 HVLP HV30 - 460
PROLT-GT110-1314 LVMP T110 - 265
NOTE: When removing air cap from retaining ring, don’t remove the Slip Ring (2) or Retaining Ring Seal (5) from
the Retaining Ring. Damage to the parts may occur. Slip ring and Retaining Ring seal are not available as
replacements. Simply wipe parts clean and reassemble with new or clean air cap.
Chart 2 – Fluid Nozzle Range & Fluid Needle
PART No. FOR FLUID NOZZLE PART No. NEEDLE
PRO-200-12-K
PRO-301-K
PRO-200-13-K
PRO-200-14-K
NOTE: When replacing the fluid nozzle or fluid needle, replace both at the same time. Torque to 18–20 Nm (160–
180 lbs.in). Do not over tighten the fluid nozzle. Use SN-28 (56) 10mm Spanner supplied with the gun and
check with a torque wrench.
To Next Page
Loading...
