15
1.It will display
“
Err
”
when the carrier level
is less than 85 dB
μ
V.
2.When C/N>=50dB
，
it always displays
“50dB”.
3.When C/N<=20dB
，
it displays “20dB”.
4.If you want to test C/N again, you must
press C/N for three times.
5.The carrier-off test mode is more exact. If
you want to get an accurate testing result
you need a spectrum analyzer and shut off
the modulation when testing.
V．Vol tage Test
Press CH/F in SINGLE FREQUENCY TEST mode to
access TRUNK/BATTERY VOLTAGE test mode.
To Next Page
