DeWalt 1325845 - Page 23

21
English
PROBLEM SOLUTION
Motor does not run
Check power cord, plugs and outlet.
Ensure the on/off switch is in the
ON position ( I )
Remove blockages in the oor
nozzle, extension wands, hose
or lter.
Replace the disposable dust bag.
Clean or replace the lter.
Empty dust tank, refer to EMPTY
THE TANK under OPERATING
INSTRUCTIONS.
Check for proper installation of
the lter.
Suction capacity
decreases
Vacuum stops
running
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
2. Empty the dust tank, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position ( I ) to
test.
Ensure lters are not damaged;
replace if necessary.
Ensure lter seals are in place and
are secure.
Check the t of the vacuum head.
Check for proper installation of the
lters.
Dust comes out
while vacuuming
WARNING:
If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or
similarly qualied persons in order to avoid a hazard.
WARNING:
This product is NOT to be used for ltering of pathogens,
for example COVID-19. Follow all local, state and federal
guidance on general cleaning practices.
YEAR
LIMITED
GUARANTEE
3
TOOL GUARANTEE