Need help?Do you have a question about the DeWalt 790 and is the answer not in the manual?
General| Type | Sliding Compound Miter Saw |
|---|---|
| Amperage | 15 amps |
| Weight | 56 lbs |
| Bevel Capacity | 48° left and right |
| Miter Capacity | 50° left and right |
Explains the importance of grounding and proper plug connection for safety.
Lists model numbers with corresponding voltage and phase requirements.
Step-by-step guide for unpacking and assembling the saw.
Details technical specifications for the saw model.
Adjusting rip, miter, and bevel scales for accurate measurements and cuts.
Aligning table, fence, yoke clamp, and arm clamp for precision.
Adjusting bevel clamp and rollerhead bearings for stability and smooth movement.
Adjusting base, column, and blade perpendicularity for stability.
Aligning cross-cut travel with fence and arm tracks for square cuts.
Comprehensive list of safety precautions for stationary power tools.
Best practices for tool upkeep and operational procedures.
Specific cautions and advice for using the lower blade guard.
Explanation of the manual-reset overload protector and its function.
Critical safety warnings and kickback prevention strategies.
Instructions for pusher boards and general setup.
Procedures for arm rotation, swivel, tilt, and basic cut setups.
Step-by-step guides for common cross, miter, and rip cuts.
Instructions for bevel, plough, dado, shaping, and sanding.
Step-by-step process to cut kerf marks on the table top.
Electrical wiring diagram for 120V operation.
Electrical wiring diagram for 240V operation.
Catalog of available saw blades with specifications.
Details on roller stop, return device, guards, and splitter.
Accessories for shaping, routing, planing, saber saw, and dado.
Details of the one-year limited warranty for the product.
To Next Page
