ENGLISH
9
c) Lower guard should be retracted manually
only for special cuts such as “plunge cuts”
and “compound cuts.” Raise lower guard
by retracting handle and as soon as blade
enters the material, the lower guard must
be released. For all other sawing, the lower
guard should operate automatically.
d) Always observe that the lower guard is
covering the blade before placing saw
down on bench or floor. An unprotected,
coasting blade will cause the saw to walk
backwards, cutting whatever is in its path. Be
aware of the time it takes for the blade to stop
after switch is released.
Additional Safety Instructions for
Circular Saws
• Wear ear protectors. Exposure to noise can
cause hearing loss.
• Wear a dust mask.
• Do not use blades of larger or smaller
diameter than recommended. For the proper
blade rating refer to the technical data. Use only
the blades specified in this manual.
• Never use abrasive cut-off wheels.
Residual Risks
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of personal injury due to flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
DATE CODE POSITION (FIG. 1)
The date code (g), which also includes the year of
manufacture, is printed into the housing.
Example:
2014 XX XX
Year of Manufacture
Package Contents
The package contains:
1 Circular saw
1 Parallel fence
1 Dust mouth
2 Pan head screws M5
1 Saw blade
1 Saw blade wrench
1 Saw blade clamp:
1 Inner washer
1 Outer washer
1 Blade clamping screw
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. On/off switch
b. Lock-off button
c. Front handle
d. Spindle lock
e. Dust extraction outlet
f. Saw shoe
g. Date code
h. Lower guard retracting lever
i. Lower blade guard
j. Saw blade
k. Bevel adjustment knob
l. Mark for bevel cut
m. Mark for straight cut
n. Depth adjustment knob
o. Parallel fence
INTENDED USE
Your D23700 circular saw has been designed for
professional sawing of wood and plastic.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
To Next Page
Loading...
