ENGLISH
10
This circular saw is a professional power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your DEWALT tool is double insulated in
accordance with IEC 60745; therefore no
earth wire is required.
WARNING: 127 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
DEWALT service organisation.
Mains Plug Replacement
(Middle East and Africa)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs.
Recommended fuse: 13A 220–240V; 16A 127V.
Using an Extension Cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see Technical Data). The minimum conductor
size is 1.5 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Assemble the Blade (fi g. 5)
1. Place the inner washer (t) onto the shaft.
2. Retract the lower blade guard (i) using the lever
(h) and install the blade (j) and the outer washer
(s).
3. Check the direction of rotation of the blade.
4. Thread on the blade clamping screw (r) by hand
to hold the washer in position. Turn clockwise.
5. Press the spindle lock button (d) while turning
the spindle until the blade stops rotating.
6. Tighten the blade clamping screw firmly using
the wrench.
Depth of Cut Adjustment (fi g. 1, 2)
1. Loosen the depth adjustment knob (n).
2. Move the shoe (f) to obtain the correct depth of
cut.
3. Tighten the depth adjustment knob (n).
WARNING: For optimal results, allow
the saw blade to protrude from the
workpiece by about 3 mm (see inset in
figure 2).
Bevel Adjustment (fi g. 3)
The bevel angle can be adjusted between 0° and
45°.
1. Loosen the bevel adjustment knob (k).
2. Set the bevel angle by tilting the saw shoe (f)
until the mark indicates the desired angle on the
scale.
3. Tighten the bevel adjustment knob (k).
Shoe Adjustment for 90° Cuts
(fi g. 1, 4)
1. Adjust the saw to 0° bevel.
2. Retract the blade guard using the lever (h) and
place the saw on the blade side.
3. Loosen the bevel adjustment knob (k).
To Next Page
Loading...
