DeWalt D25501-AR

ENGLISH
28
5. Depress the trigger switch
1
.
6. Apply only enough pressure to engage active vibration
control (refer to Active VibrationControl).
7. To stop the tool, release the trigger switch.
Always turn the tool off when work is finished and
beforeunplugging.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can causeinjury.
Your D
e
WALT power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regularcleaning.
Lubrication
Your tool was properly lubricated before leaving the
factory. In from two to six months, depending upon use,
take or send your tool to an authorized service center for a
complete cleaning, inspection and lubrication. Tools used
constantly on production jobs will need relubrication more
often. Also, tools “out of service” for long periods should be
relubricated before being put back towork.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performingthis.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into aliquid.
Accessories

WARNING: Since accessories, other than those
offered by
DeWALT
, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
DeWALT
recommended accessories should be used with
thisproduct.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
servicecenter.
MAXIMUM CAPACITY
D25501 D25601 D25602 D25831 D25851
Concrete 1–9/16"
(40 mm)
1–3/4"
(45 mm)
1–3/4"
(45 mm)
– –
RPM 490 490 210–415 – –
No load
BPM
3300 3300
1430–
2840
1430–
2840
1430–
2840
Repairs
The charger and battery pack are notserviceable.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a
DeWALT
factory service center
or a
DeWALT
authorized service center. Always use
identical replacementparts.
Protecting the Environment
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal householdwaste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to localprovisions.