Hot Surfaces
PUMP
FIG. 2 CYLNDER
AND
OUTLET TUBE CHECK /
VALVE /
CHECK
OUTLET TUBE VALVE
Definitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and
pay attention to these symbols.
`&DANGER: Indicates an imminently hazardous
situation which, ff not avoided, wifl result in death
or serious injury.
AWARNING: Indicates a potentially hazardous
situation which, ff not avoided, could result in death
or serious injury.
,&CAUTION: Indicates a potentially hazardous
situation which, ff not avoided, may result in minor
or moderate injury.
CAUTION: Used without the safety alert symbol
indicates a potentially hazardous situation which, ff
not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT
THIS OR ANY DEWALT TOOL, CALL US TOLL FREE AT:
I=800=4=DEWALT (1-800=433=9258)
Important Safety Instructions
_, WARNING: Do not operate this unit until you read and understand
this instruction manual for safety, operation and maintenance
instructions.
AWARNING: Some dust created by power sanding, sawing, grind-
ing, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some example of these chemicals are:
* lead from lead-based paints
* crystalline silica from bricks and cement and other masonry
products
* arsenic and chromium from chemically-treated lumber
Your risk from these exposures varies, depending on how often
you do this type of work. To reduce your exposure to these chemi-
cals: work in a weft ventilated area, and work with approved safety
equipment, always wear OSHA/MSHA/NIOSH approved, properly
fitting face mask or respirator when using such tools.
When using air tools, basic safety precautions should always be fol-
lowed to reduce the risk of of personal injury,
_ WARNING: This product contains chemicals, including lead,
known to the State of California to cause cancer, and birth
defects or other reproductive harm. Wash hands after handling.
SAVE THESE INSTRUCTION
To Next Page
Loading...
Need help?
General
