DeWalt D55684

23
English
Troubleshooting Codes
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
1 Unloader valve does not release pressure
when air tank reaches blow-off pressure
Unloader valve must be replaced. Contact a D
E WALT factory service center
or a D
E WALT authorized service center.
2 Fittings are not tight Tighten fittings where air can be heard escaping. Check fittings with soapy
water solution. DO NOT OVERTIGHTEN.
3 Defective unloader valve Turn off engine, rotate manual lock unloader lever to the closed perpendicular
position. If air leaks out of air tank through unloader valve, replace unloader
valve.
4 Defective air tank Air tank must be replaced. Do not repair the leak.
WARNING: Risk of bursting. Do not drill into, weld or otherwise modify air
tank or it will weaken. The air tank can rupture or explode.
5 Leaking seals Contact a DEWALT factory service center or a D E WALT authorized service
center.
6 Defective safety valve Operate safety valve manually by pulling on ring. If valve still leaks, it must
be replaced.
7 Prolonged excessive use of air Decrease amount of air usage.
8 Compressor is not large enough for acces-
sory
Check the accessory air requirement. If it is higher than the SCFM or pres-
sure supplied by your air compressor, a larger compressor is needed to
operate accessory.
9 Hole in air hose Check and replace air hose, if required.
10 Unloader valve restricted Remove, clean or replace.
11 Unit operating in damp or humid conditions Move unit to a dry well ventilated area.
12 Restricted air intake filter Clean or replace air intake filter.