DeWalt DCF6202 - Additional Features and Information; Installing the Advancing Mechanism; Removable Shoe; Optional Accessories

6
ENGLISH
Protecting the Environment
Separate collection. Products marked with this symbol
must not be disposed of with normal householdwaste.
Products contain materials that can be recovered
or recycled reducing the demand for raw materials.
Please recycle electrical products according to local provisions.
Further information is available at www.2helpU.com.
• PH2 Extended Bit x 5 - DT20425
Optional Accessories

WARNING: Since accessories, other than those offered by
DeWALTSTANLEY, have not been tested with this product,
use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only DeWALTSTANLEY
recommended accessories should be used with
thisproduct.
Consult your dealer for further information on the
appropriateaccessories.
To Install Advancing Mechanism
1. With the collated magazine attachment removed from
screwdriver, align the tabs
12
on the shoe with the
slots
13
in the collatedhousing.
2. Push in slightly, then align the spring
14
with the pocket in
the advancingmechanism.
3. Push advancing mechanism in until you hear the “click” of
the service button. The release lever
11
should click into
place in its slot. You may need to pull down on the lever to
help it if it does not click inplace.
NOTE: The release lever
11
should be in the down position
(as shown in FigureE) before the advancing mechanism is
installed. If in the up position, the advancing mechanism will
be locked inplace.
4. Cycle the advancing mechanism several times by hand
to ensure proper function before installing it onto your
screwdriver foruse.
Removable Shoe (Fig. F)
Removing the shoe allows closer access tocorners.
1. To remove shoe
7
on front of the unit, remove the two
screws
15
using a T10 Torx. Pull shoe straight off to remove.
2. To reinstall, push shoe onto advancing mechanism until
screw holes line up. Reinstallscrews.