Need help?Do you have a question about the DeWalt DWE46225 and is the answer not in the manual?
General| Dust Collection | Yes |
|---|---|
| Accessory Type | Dust Shroud |
| Fits Tool Type | Angle Grinders |
| Maximum Wheel Diameter | 5 in |
| Wheel Diameter | 5 inches |
| Spindle Thread | 5/8"-11 |
Defines DANGER, WARNING, CAUTION, NOTICE, and symbol meanings for hazard identification.
Instructions to read all warnings, save them for future reference, and understand tool operation.
Covers guards, blades, speed, flanges, wheel size, arbour fit, damaged wheels, PPE, bystanders, and grip.
Includes advice on bouncing wheels, metal cutting, wheel storage, wiring, dust collection, usage duration, air vents, and clothing.
Explains kickback and provides prevention methods: grip, body position, corners, pressure, binding, and workpiece support.
Covers accessory use, workpiece securing, side handle, wheel handling, cutting methods, wiring, metal cutting, dust collection, and usage duration.
Highlights risks from flying particles, burns, prolonged use, hearing impairment, and recommends RCD usage.
Lists all items included in the product package for user verification.
Explains pictograms on the tool and identifies the location of the date code, including the year of manufacture.
Lists and identifies specific parts of the cutting shroud and grinder as depicted in Figure A.
Specifies use for masonry cutting, not metal/wood; dry use only; prohibits wet conditions or flammable liquids; restricts unsupervised use by children/infirm.
Emphasizes turning off the tool and disconnecting power before making any adjustments or installing/removing accessories.
Detailed instructions for mounting the 125mm cutting shroud onto a keyless gear case grinder.
Detailed instructions for mounting the 230mm cutting shroud onto a grinder gear case.
Safety and procedural guidance for mounting keyed guards specifically on 230mm grinders.
Cautionary note that keyed guards only mount on grinders where the 230mm shroud was previously mounted.
Specifies the mandatory use of Type 1 guards for cutting metal or masonry, available at extra cost.
Instructions for mounting diamond wheels, including flange compatibility, wheel placement, and spindle lock tightening.
Procedure for loosening the knob, sliding the adjustor, and re-tightening to set the desired cutting depth.
Guidance on connecting DEWALT dust extractors via DWV9000 connector or traditional hoses for dust collection.
Instructions for removing the clips, wheels, and pivot pin, and for reattaching them securely.
Admonishes users to observe safety instructions and applicable regulations during operation.
Step-by-step guide for performing tuckpointing and cutting, including depth setting, tool speed, positioning, and plunge cuts.
Recommends using dry air for dirt removal and warns against solvents or harsh chemicals for cleaning.
Notes that the tool is designed for long operation with minimal maintenance and requires no additional lubrication.
Warns against using non-DEWALT accessories due to potential hazards and recommends consulting dealers.
Advises on proper disposal of products marked with the symbol and recycling of electrical products according to local provisions.
To Next Page
