DeWalt DWE46225 - Operation Instructions; General Operation Safety; Tuckpointing and Cutting Application; Cleaning and Maintenance

9
ENGLISH
Protecting the Environment
Separate collection. Products marked with this symbol
must not be disposed of with normal householdwaste.
Products contain materials that can be recovered
or recycled reducing the demand for raw materials.
Please recycle electrical products according to local provisions.
Further information is available at www.2helpU.com.
Lubrication
Your power tool requires no additionallubrication.
MAINTENANCE
Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regularcleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can causeinjury.
Tuckpointing and Cutting Application
(Fig. A, J)
1. Set the desired depth of cut, see Depth of Cut Adjustment
under Assembly andAdjustments.
2. Allow the tool to reach full speed before touching it to the
worksurface.
3. Position yourself so the open underside of the shroud and
the wheel are facing away fromyou.
4. Place the metal base
3
of the shroud onto the work surface
and begin cut by plunging into the work surface. The upper
shroud
9
will lock onto the lower shroud
10
after the
initialplunge.
NOTE: Keep the metal base of the shroud against the work
surface to ensure proper dustcollection.
5. With the shroud oriented as shown in FigureJ, pull the
grinder along the worksurface.
NOTE: The grinder should ONLY be used in the
directionindicated.
6. When finished with the cut, remove the tool from work
surface before turning off the tool. Allow the tool to stop
rotating before laying itdown.
7. Push the side shroud button
8
to release the upper shroud
and start a new plunge andcut.
OPERATION
Instructions for Use

WARNING: Always observe the safety instructions and
applicableregulations.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can causeinjury.
Optional Accessories

WARNING: Since accessories, other than those offered
by
DeWALT
, have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only
DeWALT
recommended
accessories should be used with thisproduct.
Consult your dealer for further information on the
appropriateaccessories.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing thisprocedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into aliquid.
2. Remove thewheels.
3. Remove the pivot pin
28
.
To attach the wheels to the base, reinsert the pivot pin, slide the
wheels on their axles and secure the clips in place. Make sure all
four wheels are securely attached before using the