What to do if grease appears in the relief valve of my DeWalt Paint Sprayer?
If grease appears in the relief valve of your DeWalt Paint Sprayer, it's likely because the zerk fitting is blocked. Disconnect the coupler from the fitting, then clean both the zerk fitting and the grease path.
Why am I unable to push the rod forward on my DeWalt Paint Sprayer?
If you can't push the rod forward on your DeWalt Paint Sprayer, it could be due to pressure build-up or because the rod is still connected to the plunger. Try unscrewing the purge valve to release pressure. If that doesn't work, rotate the grease tube handle 90 degrees to disengage it.
How to fix unable to pull back rod on DeWalt Paint Sprayer?
If you're unable to pull back the rod on your DeWalt Paint Sprayer, it's likely due to vacuum build-up. Unscrew the purge valve to release the vacuum.
What to do if my DeWalt Tools dispenses no grease when trigger is pulled?
If your DeWalt Tools doesn't dispense grease when the trigger is pulled, the possible causes are: * The grease tube is empty: Add grease. * Air pockets in the grease tube: Refer to Purging Air Pockets. * Check valve is clogged: Refer to Cleaning Contamination from the Check Valve. * Filter is clogged: Refer to Cleaning Contamination from the Filter.
What to do if I'm unable to push the rod forward on my DeWalt DCGG571?
If you are unable to push the rod forward on your DeWalt Tools, it may be due to pressure build-up. Unscrew the purge valve to release the pressure. Alternatively, the rod may still be connected to the plunger; rotate the grease tube handle 90 degrees to disengage it.
How to fix a DeWalt Tools if I am unable to pull back the rod?
If you are unable to pull back the rod on your DeWalt Tools, it may be due to vacuum build up. Unscrew the purge valve to release the vacuum.
Why is grease appearing in the relief valve of my DeWalt DCGG571 Tools?
If grease appears in the relief valve of your DeWalt Tools, the zerk fitting may be blocked. Disconnect the coupler from the fitting, then clean the zerk fitting and grease path.
Why does grease leak out of the back of the grease tube on my DeWalt Tools?
If grease leaks out of the back of the grease tube of your DeWalt Tools, the rubber seal might be flipped in the wrong direction. Refer to Preparing the Grease Gun for Suction and Filler Pump Filling.
General| Type | Cordless Grease Gun |
|---|---|
| Voltage | 20V |
| Max Pressure | 10, 000 PSI |
| Battery Type | Lithium-Ion |
| Battery Compatibility | 20V MAX* |
To Next Page
