DeWalt DCN660NT - Tool Description & Intended Use; Component Identification; Intended Use Guidelines; Assembly and Adjustments

11
ENGLISH
Low Battery Indicator (Fig.H)
The low battery indicator is an integrated feature in the
left-hand worklight
5
. It will blink 4 times to indicate that
the battery pack needs to be recharged and the tool will
automatically shutdown.
Switch off the tool and take out the battery pack
15
to charge it
as soon as the indicatorblinks.
The tool remains non-operational as long as a low battery pack
is attached toit.
Mounting the Belt Hook (Fig. C)
The belt hook may be attached to either side of the tool or
removed if notdesired.
Inserting and Removing the Battery Pack
from the Tool (Fig.B)
NOTE: Make sure your battery pack
15
is fullycharged.
To Install the Battery Pack into the Tool Handle
1. Align the battery pack
15
with the rails inside the tool’s
handle (Fig. B).
2. Slide it into the handle until the battery pack is firmly seated
in the tool and ensure that you hear the lock snap intoplace.
To Remove the Battery Pack from the Tool
1. Press the release button
16
and firmly pull the battery pack
out of the toolhandle.
2. Insert battery pack into the charger as described in the
charger section of thismanual.
Fuel Gauge Battery Packs (Fig.B)
Some DEWALT battery packs include a fuel gauge which
consists of three green LED lights that indicate the level of
charge remaining in the batterypack.
To actuate the fuel gauge, press and hold the fuel gauge
button
 
. A combination of the three green LED lights will
illuminate designating the level of charge left. When the level
of charge in the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to berecharged.
NOTE: The fuel gauge is only an indication of the charge left on
the battery pack. It does not indicate tool functionality and is
subject to variation based on product components, temperature
and end-userapplication.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can causeinjury.

WARNING: Use only DEWALT battery packs andchargers.
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
Trigger switch
2
Contact trip
3
Jam clearing latch
4
Stall release lever
5
Worklights/fault indicator
6
Reversible belt hook
7
Non-mar tip holder
8
Nail pusher
9
Magazine
10
Mode selector switch (DCN660 only)
11
Depth adjustment wheel
12
Depth indicator
13
Trigger lock-off
14
Non-mar tip
15
Battery pack
16
Battery release button
Intended Use
Your 16 GA finish nailer has been designed for professional
nailing and tackingapplications.
DO NOT use under wet conditions or in the presence of
flammable liquids orgases.
These 16 GA finish nailers are professional powertools.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
thistool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
Date Code Position
The date code

, which also includes the year of manufacture, is
printed into thehousing.
Example:
2020 XX XX
Year of Manufacture
Magazinecapacity.
Toolvoltage.
Magazine angle: 20˚.
Visible radiation. Do not stare intolight.
unless they are supervised by a person responsible for their
safety. Children should never be left alone with thisproduct.