English
11
where the
surrounding air
temperature is
approximately 65
°F – 75 °F (18 ° –
24 °C);
d. If charging
problems persist,
take the tool,
battery pack and
charger to your
local service
center.
4. The battery pack
should be recharged
when it fails to
produce sufficient
power on jobs which
were easily done
previously. DO NOT
CONTINUE to use
under these
conditions. Follow the
charging procedure.
You may also charge a
partially used pack
whenever you desire
with no adverse effect
on the battery pack.
5. Foreign materials of a
conductive nature
such as, but not
limited to, grinding
dust, metal chips,
steel wool, aluminum
foil, or any buildup of
metallic particles
should be kept away
from charger cavities.
Always unplug the
charger from the
power supply when
there
is no battery pack in
the cavity. Unplug
the charger before
attempting to clean.
6. Do not freeze or
immerse the charger
in water or any other
liquid.
Storage Recommendations
1. The best storage place is one that is cool and dry, away from direct sunlight and
excess heat or cold.
2. For long storage, it is recommended to store a fully charged battery pack in a
cool dry place out of the charger for optimal results.
nOTE: Battery packs should not be stored completely depleted of charge. The
battery pack will need to be recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE COMPONENTS (FIG. A)
WARNING: Never modify the power tool or any part of it. Damage or personal
injury could result.
Refer to Figure A at the beginning of this manual for a complete list of
components.
Intended Use
The DCN692 cordless framing nailer has been designed for driving nails into
wooden workpieces. DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This cordless framing nailer is a professional power tool. DO nOT let children come
into contact with the tool.
Supervision is required when inexperienced operators use this tool.
TOOL SPECIFICATIONS
Firing Mode selective: Bump or sequential
To Next Page
Loading...
