English
17
nOTE: Should nails jam
frequently or the driver
blade continually fail to
reset, have tool serviced
by an authorized
DeWALT service center.
Cold Weather
Operation
When operating tools at
temperatures below
freezing:
1. Keep tool as warm as
possible prior to use.
2. Actuate the tool 10 or
15 times into scrap
lumber before using.
Hot Weather
Operation
Tool should operate
normally. However,
keep tool out of direct
sunlight as excessive
heat can deteriorate
bumpers and other
rubber parts resulting in
increased maintenance.
Rotating Rafter
Hook (Fig. M)
WARNING: Never use
hook to hang tool from
belt or
other clothing unless
tool is in sequntial action
mode.
WARNING: Remove
nails from magazine
before making any
adjustments or
servicing this tool.
Failure to do
so may result in
serious injury.
CAUTION:
When not in use, place
tool on its side on a
stable surface where it
will not cause a
tripping or falling
hazard.
CAUTION: Some tools with large battery packs will stand upright on the battery
pack but may be easily knocked over.
The DeWALT cordless nailer includes a rotating rafter hook 10 and can be easily
positioned to the left or right of the tool to accommodate left- or right-handed
users.
If use of the hook is not desired at all, it can be rotated to the front or back of
the handle base. Fig. M
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn unit off and
remove the battery pack before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least
once a week. To minimize the risk of eye injury, always wear ANSI Z87.1
approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any part of the tool into
a liquid.
Accessories
WARNING: Since accessories, other than those offered by DeWALT, have not
been tested with this product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only DeWALT recommended
accessories should be used with this product.
Recommended accessories for use with your tool are available at extra cost
from your local dealer or authorized service center. If you need assistance in
locating any accessory, please contact DeWALT Industrial Tool Co., 701 East
Joppa Road, Towson, MD 21286, call 1-800-4-DeWALT (1-800-433-9258) or visit
our website: www.dewalt.com.
Replacing the Return Springs and Profile
WARNING: For your own safety, read the tool instruction manual before using
any accessory.
To Next Page
Loading...
