DeWalt DCN692 - Page 20

English
18
Failure to heed these
warnings may result in
serious personal injury
and damage to the tool
and the accessory.
When servicing this
tool, use only identical
replacement parts.
CAUTION: If you don't
feel comfortable
servicing your tool,
take it to a DeWALT
authorized service
center. The user should
only attempt to service
the springs and profile.
All other service should
be completed by
an authorized
DeWALT service
center.
CAUTION: Do not
lubricate any of the
replacement parts.
Lubrication can damage
the parts and seriously
affect the life and
performance of the tool.
NOTICE: All the
mechanical parts
of the spring
replacement kit
are shown for
convenience and
verification of
inclusion. The kit
also contains a
packet of Loctite
adhesive for use
in Step 9. Refer to
Fig. S.
DCN6901 Return
Spring Replacement
Kit (Fig . N–S)
To Change Broken or
Worn Return springs
nOTE: Springs should be
replaced as a pair, using
only the correct DeWALT
accessory spring
replacement kit.
1. Using the key 11 provided, loosen the two screws 19 on either side of the unit.
Refer to Figure N.
2. Remove the return system 20 from the unit. Refer to Figure O.