EasyManuals Logo

DeWalt DCS727 Manual

DeWalt DCS727
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
ENGLISH
Protecting the Environment
Separate collection. Products and batteries marked with this
symbol must not be disposed of with normal householdwaste.
Products and batteries contain materials that can be recovered or
recycled reducing the demand for raw materials. Please recycle
electrical products and batteries according to local provisions. Further
information is available at www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to produce
sufficient power on jobs which were easily done before. At the end of its
technical life, discard it with due care for our environment:
Run the battery pack down completely, then remove it from thetool.
Li‑Ion cells are recyclable. Take them to your dealer or a local recycling
station. The collected battery packs will be recycled or disposed
ofproperly.
Clamp: DW7090‑XJ (Fig.C)
The clamp
39
is used for firmly clamping workpiece to the sawtable.
Quick Release Clamps: DWS5026‑XJ
Dust Bag: DW7053‑QZ (Fig.D)
Equipped with a zipper for easy emptying, the dust bag
40
will capture the
majority of the sawdustproduced.
Leg Stands: DE7023‑XJ, DE7033‑XJ (Fig.E)
The leg stand
41
is used to extend the table width of thesaw.
Clamp Brackets: DE7025‑XJ (Fig.F)
The clamp brackets
42
are used for mounting the saw to astand.
SAW BLADES: ALWAYS USE 250 mm SAW BLADES WITH 30 mm ARBOUR
HOLES. SPEED RATING MUST BE AT LEAST 4300RPM. Never use a smaller
diameter blade. It will not be guarded properly. Use crosscut blades only!
Do not use blades designed for ripping, combination blades or blades with
hook angles in excess of 5°.
BLADE DESCRIPTIONS
APPLICATION DIAMETER TEETH
Construction Saw Blades (thin kerf with anti‑stick rim)
General Purpose 250 mm 40
Fine Crosscuts 250 mm 60
Woodworking Saw Blades (provide smooth, clean cuts)
Fine crosscuts 250 mm 80
Non‑ferrous metals 250 mm 96
Optional Accessories
WARNING: Since accessories, other than those offered by DEWALT,
have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only DEWALT
recommended accessories should be used with thisproduct.
Consult your dealer for further information on the appropriateaccessories.

Other manuals for DeWalt DCS727

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt DCS727 and is the answer not in the manual?

DeWalt DCS727 Specifications

General IconGeneral
BrandDeWalt
ModelDCS727
CategorySaw
LanguageEnglish

Related product manuals