DeWalt DCS7485

15
ENGLISH
Have defective cords replacedimmediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indooruse.
Discard the battery pack with due care for
theenvironment.
Charge
DeWALT
battery packs only with designated
DeWALT
chargers. Charging battery packs other
than the designated
DeWALT
batteries with a
DeWALT
charger may make them burst or lead to
other dangeroussituations.
Do not incinerate the batterypack.
Use: Use without transportation cap, Wh rating
indicates 108 Wh (1 battery with 108 Wh).
Transport: Transport with built-in transport cap, Wh
rating indicates 3 x 36 Wh (3batteries of 36 Wh).
Battery Type
The DCS7485 operates on a 54 volt batterypack.
These battery packs may be used: DCB546. Refer to Technical
Data for moreinformation.
Package Contents
The package contains:
1 Partly assembled machine
1 Rip fence assembly
1 Mitre fence
1 Saw blade
1 Upper blade guard assembly
1 Throat plate
2 Blade wrenches
1 Dust extraction adapter
1 Battery charger (T2)
2 Li-Ion battery packs (T2)
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual beforeuse.
Wear earprotection.
Wear eyeprotection.
Wear facemask.
Keep hands away from cutting area and theblade.
Carryingpoint.
Remove battery when changing blade, installing/
removing accessories and making adjustment/repairs.
Date Code Position (Fig. A)
The date code
49
, which also includes the year of manufacture,
is printed into thehousing.
Example:
2016 XX XX
Year of Manufacture
Description (Fig. A, D)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
Table
2
Blade
3
Rip scale indicator
4
Fine adjust knob
5
Rail lock lever
6
Blade height adjustment
wheel
7
Bevel lock lever
8
ON/OFF assembly
9
Mounting holes
10
Mitre gauge
11
Blade guard assembly
12
Battery
13
Battery release button
14
Carry handle
15
Dust collection port
16
Guard dust collection port
17
Throat plate
18
Rip fence
19
Rip fence latch
20
Narrow ripping fence/
support extension
21
Blade wrenches (stored
position)
22
Push stick (stored position)
23
Riving knife (non thru
sawing) (Fig.D)
24
Mitre gauge storage
Intended Use
Your table saw has been designed for professional ripping,
cross-cutting, mitreing and bevelling with various materials as
wood analogous materials andplastic.
DO NOT use for cutting metal, cement board, ormasonry.
DO NOT use under wet conditions or in presence of flammable
liquids orgases.
These table saws are professional powertools.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
thistool.
Ташев-Галвинг ООД
www.tashev-galving.com