How to fix pressure drops on the DeWalt DPC16PS-QS gauge when using accessories?
It's normal for some pressure drop to occur when an accessory is used. If the pressure drop is excessive, adjust the regulator as instructed in Regulator under Features. Make sure to adjust the regulated pressure under flow conditions while the accessory is being used.
Why is there moisture in the crankcase of my DeWalt Air Compressor?
If there's moisture in the pump crankcase of your DeWalt Air Compressor, it's likely due to operating the unit in damp or humid conditions. To resolve this, move the unit to a dry, well-ventilated area.
What to do if my DeWalt DPC16PS-QS motor will not run?
If your DeWalt Air Compressor motor won't run, there are several potential reasons. The motor overload protection switch may have tripped, so check the 'Motor Overload' section. Ensure you're using the correct length and gauge of extension cord. Blown fuse, circuit breaker tripped can also cause this issue. Check the fuse box and replace fuses as needed, or reset the circuit breaker, but do not use a fuse or circuit breaker with a higher rating than specified. Check for proper fuse and use only a time delay fuse. Check for low voltage conditions and/or proper extension cord. Disconnect other electrical appliances from the circuit, or operate the compressor on its own branch circuit. Loose electrical connections, a defective motor or starting capacitor, or paint spray on internal motor part...
Why does the safety valve pop off on my DeWalt DPC16PS-QS Air Compressor?
If the safety valve pops off due to excessive air tank pressure, several issues might be at play. The pressure switch may not be shutting off the motor when the compressor reaches the cut-out pressure; in this case, immediately set the On/Off switch to OFF. If it still does not shut off, contact a DWALT factory service center or a DWALT authorized service center. Alternatively, the pressure switch cut-out might be too high, which also requires contacting a service center. A defective safety valve can also cause this issue; try manually operating the safety valve by pulling on the ring. If it continues to leak, the valve needs replacement. Also, the tank pressure may exceed the pressure switch cut-in pressure, in which case the motor will start automatically when the tank pressure drops bel...
Critical safety directives for proper and safe operation of the DEWALT air compressor.
Explanation of pictograms, warning symbols, and signal word meanings used on the compressor and manual.
Steps to perform before starting the compressor to ensure safe operation and readiness.
Issue where the safety valve activates due to over-pressurization of the air tank.
Issue where the compressor's air output is insufficient for connected tools.
Troubleshooting steps when the compressor's motor fails to start.
General| Noise level | 91 dB |
|---|---|
| Intake capacity | 240 l/min |
| Air tank capacity | 16 L |
| Maximum operating pressure | 10 bar |
| Motor power | 1800 W |
| Power source | AC |
| AC input voltage | 230 V |
| Product color | Black, Yellow |
| Housing material | - |
Weight and Dimensions| Depth | 470 mm |
|---|---|
| Width | 486 mm |
| Height | 578 mm |
| Weight | 36000 g |
To Next Page
