How to fix pressure drops on the DeWalt DPC6MRC-QS gauge when using accessories?
It's normal for some pressure drop to occur when an accessory is used. If the pressure drop is excessive, adjust the regulator as instructed in Regulator under Features. Make sure to adjust the regulated pressure under flow conditions while the accessory is being used.
Why is there moisture in the crankcase of my DeWalt DPC6MRC-QS?
If there's moisture in the pump crankcase of your DeWalt Air Compressor, it's likely due to operating the unit in damp or humid conditions. To resolve this, move the unit to a dry, well-ventilated area.
What to do if my DeWalt Air Compressor motor will not run?
If your DeWalt Air Compressor motor won't run, there are several potential reasons. The motor overload protection switch may have tripped, so check the 'Motor Overload' section. Ensure you're using the correct length and gauge of extension cord. Blown fuse, circuit breaker tripped can also cause this issue. Check the fuse box and replace fuses as needed, or reset the circuit breaker, but do not use a fuse or circuit breaker with a higher rating than specified. Check for proper fuse and use only a time delay fuse. Check for low voltage conditions and/or proper extension cord. Disconnect other electrical appliances from the circuit, or operate the compressor on its own branch circuit. Loose electrical connections, a defective motor or starting capacitor, or paint spray on internal motor part...
Why does the safety valve pop off on my DeWalt Air Compressor?
If the safety valve pops off due to excessive air tank pressure, several issues might be at play. The pressure switch may not be shutting off the motor when the compressor reaches the cut-out pressure; in this case, immediately set the On/Off switch to OFF. If it still does not shut off, contact a DWALT factory service center or a DWALT authorized service center. Alternatively, the pressure switch cut-out might be too high, which also requires contacting a service center. A defective safety valve can also cause this issue; try manually operating the safety valve by pulling on the ring. If it continues to leak, the valve needs replacement. Also, the tank pressure may exceed the pressure switch cut-in pressure, in which case the motor will start automatically when the tank pressure drops bel...
Highlights critical safety precautions for compressor use and general warnings.
Lists the first set of 14 essential safety rules for safe compressor operation.
Continues the essential safety rules for safe compressor operation (points 15-32).
Procedures for checking oil level and recommended oil types for the DPC16PS.
Lists essential items to verify before operating the compressor.
Instructions for initial setup and the required break-in process for new compressors.
Explains how to start the compressor and its automatic pressure control system.
Details causes and solutions for various common compressor malfunctions.
Covers further issues like hose problems, regulator damage, and electrical faults.
General| Product color | Black, Red, Yellow |
|---|---|
| Housing material | - |
| Oil-free maintenance | Yes |
| Intake capacity | 170 l/min |
| Air tank capacity | 6 L |
| Sound power level | 97 dB |
| Sound pressure level | 77 dB |
| Maximum operating pressure | 8 bar |
| Sound power level uncertainty | 1.5 dB |
| Motor power | 1100 W |
| Power source | AC |
| AC input voltage | 230 V |
Weight and Dimensions| Depth | 360 mm |
|---|---|
| Width | 445 mm |
| Height | 400 mm |
| Weight | 12800 g |
To Next Page
