EasyManua.ls Logo

DeWalt DW03101 - Technical Data

DeWalt DW03101
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Dewalt DW03101
17
EN
Technical Data
* applies for 100 % target reflectivity (white painted
wall), low background illumination, 25 ºC
** applies for 10 to 500 % target reflectivity, high back-
ground illumination, - 10 ºC to + 50 ºC
*** Tolerances apply from 0.05 m to 10 m with a confi-
dence level of 95%. The maximum tolerance may
deteriorate to 0.1 mm/m between 10 m to 30 m and to
0.2 mm/m for distances above 30 m
**** applies for 100 % target reflectivity, background
illumination of approximately 30'000 lux
***** after user calibration. Additional angle related
deviation of +/- 0.01° per degree up to +/-45° in each
quadrant. Applies at room temperature. For the whole
operating temperature range the maximum deviation
increases by +/- 0.1°.
For accurate indirect results, the use
of a tripod is recommended. For
accurate tilt measurements a trans-
verse tilt should be avoided.
Distance measurement
Typical Measuring Tolerance* ± 1.0 mm / 0.04 in ***
Maximum Measuring Toler-
ance**
± 2.0 mm / 0.08 in ***
Range of target plate 100 m / 330 ft
Typical Range* 80 m / 262 ft
Range at unfavourable condi-
tion ****
60 m / 197 ft
Smallest unit displayed 0.1 mm / 1/32 in
Ø laser point
at distances
6 /30 / 60 mm
(10 / 50 / 100 m)
Tilt measurement
Measuring tolerance to laser
beam*****
± 0.2°
Measuring tolerance to
housing*****
± 0.2°
Range 360°
General
Laser class 2
Laser type 635 nm, < 1 mW
Beam divergence 0.16 x 0.6 mrad
Impulse duration 0.2 x 10
-9
s - 0.8 x 10
-9
s
Autom. laser switch off after 90 s
Autom. power switch-off after 180 s
Battery durability (2 x AAA) up to 5000 measure-
ments
Dimension (H x D x W) 125.2 x 58 x 32.6 mm
4.9 x 2.3 x 1.3 in
Weight (with batteries) 154 g / 5.43 oz
Temperature range:
- Storage
- Operation
-25 to 70 °C
-13 to 158 °F
-10 to 50 °C
14 to 122 °F
i
Functions
Distance measuring yes
Min/Max measuring yes
Permanent measuring yes
Stake-out yes
Addition/Subtraction yes
Area yes
Volume yes
Pythagoras 2-point, 3-point,
partial height
Smart Horizontal Mode /
Indirect height
yes
Height tracking yes
Levelling yes
Memory 20 displays
Beep yes
Illuminated display yes
Multifunctional endpiece yes
Protection class IP65 (dust- and splash
water protected)

Other manuals for DeWalt DW03101

Related product manuals