English
5
Your saw is capable of cutting baseboard moldings 0.9"
(22.9mm) thick by 6.0" (152.4mm) tall on a 45˚ right or left
miter.
NOTE: Your saw is capable of cutting the following once a
special setup procedure is followed (see Special Cuts).
0˚ miter height 1.5" (38.1 mm)
width 10" (255 mm)
45˚ miter height 1.5" (38.1 mm)
width 7.5" (190.5 mm)
DRIVE
120 Volt Motor
1675 Watts (max in) 15 Amp Motor
3600 RPM Cut Helical Gears
Multi-V Belt Roller Bearings
Automatic Electric Brake Carbide Blade
Press down lightly on the operating handle and pull out the
lock down pin, as shown in Figure 2. Gently release the
downward pressure and hold the arm allowing it to rise to its
full height. Use the lock down pin when carrying the saw
from one place to another. Always use the carrying handle
to transport the saw or the hand indentations shown in
Figure 2.
Bench Mounting
Holes are provided in all four feet to facilitate bench mount-
ing, as shown in Figure 2. (Two different sized holes are
provided to accommodate different sizes of screws. Use
either hole, it is not necessary to use both.) Always mount
your saw firmly to a stable surface to prevent movement.
To enhance the tool’s portability, it can be mounted to a
piece of 1/2" or thicker plywood which can then be
clamped to your work support or moved to other job sites
and reclamped.
Familiarization
Your miter saw is fully
assembled in the carton.
Open the box and lift the saw
out by the convenient carry-
ing handle, as shown in
Figure 1.
Place the saw on a smooth,
flat surface such as a work-
bench or strong table.
Examine Figure 2 to become familiar with the saw and its
various parts. The section on adjustments will refer to
these terms and you must know what and where the
parts are.
FIG. 1
FIG. 2
GUARD
RIGHT SIDE
FENCE
MITER
LOCK LEVER
MITER
SCALE
BENCH MOUNTING
HOLES
LOCK DOWN
PIN
OPERATING HANDLE
BEVEL SCALE
TRIGGER
SWITCH
OPERATING
HANDLE
LEFT SIDE
FENCE
FENCE LOCK
KNOB
FENCE LOCK
KNOB
MOTOR
HOUSING
45˚ BEVEL
OVERRIDE
LEVERS
DUST
SPOUT
MOTOR END
CAP
0˚ BEVEL
OVERRIDE KNOB
LOCK DOWN
PIN
BEVEL STOP
33.85˚ PAWLS
CARRY HANDLE
BLADE
WRENCH
45˚
BEVEL STOP
ADJUSTMENT
SCREW
BEVEL
LOCK KNOB
HAND
INDENTATIONS
0˚ BEVEL STOP
ADJUSTMENT
SCREW
To Next Page
Loading...
