Full Warranty
DEWALT heavy duty industrial tools are warranted for one year
from date of purchase. We will repair, without charge, any defects
due to faulty materials or workmanship. Arrangements have been
made with the Industrial Tool Division of Black & Decker (U.S.)
Inc. to provide warranty repairs for D
EWALT tools. Please return
the complete unit, transportation prepaid, to any Black & Decker
(U.S.) Inc. Industrial service center or authorized service station
listed under “Tools, Electric” in the yellow pages. This warranty
does not apply to accessories or damage caused where repairs
have been made or attempted by others. This warranty gives you
specific legal rights and you may have other rights which vary
from state to state.
Cradle Mounting (Fig. 9)
1. Cut two boards 20" long x 2" - 3" high x 4" wide.
2. Place chop saw at desired work location.
3. Place boards tightly along side, and nail to work surface
(Fig. 9).
Important!
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
Black & Decker (U.S.) Inc. Industrial service centers or other
qualified service organizations. These service organizations
service D
EWALT tools always using DEWALT replacement parts.
D
EWALT tools are serviced by the Industrial Tool Division of Black
& Decker (U.S.) Inc.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. A
complete listing of service centers is located at the end of this
manual If you need assistance in locating any accessory for your
tool, please contact your local dealer or authorized service center.
CAUTION: The use of any other accessory not recommended for
use with this tool could be hazardous.
CAUTION: Recommended saw blades for your saw are in this
manual. The use of any other accessory or attachment may be
hazardous. Use only D
EWALT 14", 4100 RPM saw blades.
ALWAYS WEAR SAFETY GLASSES. SECURE WORK IN VISE.
DISCONNECT TOOL FROM POWER SUPPLY BEFORE
CHANGING WHEEL.
8
To Next Page
Loading...
