1
IMPORTANT SAFETY INSTRUCTIONS
FOR ALL TOOLS
IMPORTANT: Please make certain that the person who is to
use this equipment carefully reads and understands these
instructions before starting operations.
WARNING: When using electric tools, basic safety
precautions should always be followed to reduce risk of fire,
electric shock, and personal injury, including the following:
READ ALL INSTRUCTIONS
Grounding Instructions
This tool should be grounded while in use to protect the
operator from electric shock. The tool is equipped with a
3-conductor cord and 3-prong grounding type plug to fit the
proper grounding type receptacle. The green (or green and
yellow) conductor in the cord is the grounding wire. Never
connect the green (or green and yellow) wire to a live terminal.
If your unit is intended for use on less than 150 V, it has a plug
that looks like that shown in sketch A. If it is for use on 150 to
250 V, it has a plug that looks like that shown in sketch D. An
adapter, sketches B and C, is available for connecting sketch A
type plugs to 2-prong receptacles. The green-colored rigid ear,
lug, or the like, extending from the adapter must be connected
to a permanent ground, such as a properly grounded outlet box.
No adapter is available for a plug as shown in sketch D.
ADAPTER SHOWN IN FIGURES B and C IS NOT FOR USE
IN CANADA. Use only 3-wire extension cords that have 3-
prong grounding-type plugs and 3-pole receptacles that accept
the tool’s plug. Replace or repair damaged cords.
Safety Instructions For All Tools
• KEEP WORK AREA CLEAN. Cluttered areas and benches
invite injuries.
• CONSIDER WORK AREA ENVIRONMENT. Don’t expose
power tools to rain. Don’t use power tools in damp or wet
locations. Keep work area well lit. Do not use tool in
presence of flammable liquids or gases.
• GUARD AGAINST ELECTRIC SHOCK. Prevent body
contact with grounded surfaces. For example; pipes,
radiators, ranges, and refrigerator enclosures.
• KEEP CHILDREN AWAY. Do not let visitors contact tool or
extension cord. All visitors should be kept away from work
area.
• STORE IDLE TOOLS. When not in use, tools should be
stored in dry, and high or locked-up place — out of reach of
children.
• DON’T FORCE TOOL. It will do the job better and safer at
the rate for which it was intended.
• USE RIGHT TOOL. Don’t force small tool or attachment to
do the job of a heavy-duty tool. Don’t use tool for purpose
not intended.
AB CD
GROUNDING PIN
GROUNDED
OUTLET
BOX
GROUNDING
MEANS
GROUNDING PIN
ADAPTER
To Next Page
Loading...
