treatment. If this occurs, stop the tool and inspect the wheel.
• Clean your chop saw periodically following the procedure in
the maintenance section.
• Do not remove wheel guard.
• Use the vise to clamp work.
• Use only wheels rated at 4100 rpm or higher.
• Allow cut off parts to cool before handling.
• Do not attempt to cut wood or masonry with this tool.
• NEVER CUT MAGNESIUM WITH THIS TOOL.
• Use chop saw in a well-ventilated area.
• Turn chop saw off before removing any pieces from the
table.
• NEVER USE A CIRCULAR SAW BLADE IN THIS CHOP
SAW.
• Firmly mount the saw as shown on page 7 to prevent
movement.
SAVE THESE INSTRUCTIONS
3
center unless otherwise indicated elsewhere in this
instruction manual. Have defective switches replaced by
authorized service center. Do not use tool if switch does
not turn it on and off.
Safety Instructions For Chop Saws
• Always wear safety goggles or other eye protection when
using this tool.
• Do not remove or loosen chain. Check that the chain is
always tightly secured to the base and arm.
• Before using, inspect each cutting wheel for cracks or flaws.
If a crack or flaw is evident—discard the wheel! The wheel
should also be inspected whenever you think the tool may
have been dropped.
• When starting the tool (with a new or replacement wheel
installed) place the tool in a well protected area. If the
wheel has an undetected crack or flaw, it should burst in
less than one minute. Never start the tool with a person in
line with the wheel. This includes the operator.
• In operation, avoid bouncing the wheel or giving it rough
To Next Page
Loading...
