DeWalt DWE7490 User Manual

DWE7490, DWE7491
Heavy-Duty 10" (254 mm) Job Site Table Saw
Scie de table industrielle de chantier de 254mm (10po)
Sierra de banco para el lugar de trabajo de 254 mm (10 pulg.) de alta resistencia
INSTRUCTION MANUAL
GUIDE D’UTILISATION
MANUAL DE INSTRUCCIONES
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA DE
GARANTÍA. ADVERTENCIA: LÉASE ESTE INSTRUCTIVO ANTES DE
USAR EL PRODUCTO.
Before returning this product call
1-800-4-DEWALT
IF YOU SHOULD EXPERIENCE A PROBLEM WITH YOUR D E WALT PURCHASE,
CALL 1-800-4-DEWALT
IN MOST CASES, A D E WALT REPRESENTATIVE CAN RESOLVE
YOUR PROBLEM OVER THE PHONE.
IF YOU HAVE A SUGGESTION OR COMMENT, GIVE US A CALL.
YOUR FEEDBACK IS VITAL TO THE SUCCESS OF D
E WALT’S QUALITY
IMPROVEMENT PROGRAM.
Questions? Visit us at www.dewalt.com
Des questions ? Rendez nous visite à www.dewalt.com
¿Tiene preguntas? Visítenos en www.dewalt.com

DeWalt DWE7490 Specifications

General

Type	Table Saw
Blade Diameter	10 inches
Arbor Size	5/8 inches
Max RPM	4800 RPM
Max Cut Depth at 90 Degrees	3-1/8 inches
Max Cut Depth at 45 Degrees	2-1/4 inches
Max Rip to Right of Blade	32-1/2 inches
Max Rip Capacity	32-1/2 inches
Weight	90 lbs
Dust Port Size	2-1/2 inches
Voltage	120V
Power Source	Corded Electric
Motor Power	15.0 Amps

Summary

Safety Information and Precautions

Safety Guidelines and Definitions

Explains safety signal words (Danger, Warning, Caution) and general safety rules.

General and Specific Safety Rules

Covers crucial safety instructions and specific rules for table saws.

Key Terms and Kickback Prevention

Defines essential terms and provides guidance on preventing kickback.

Product Specifications and Setup

Specifications, Unpacking, and Features

Details tool specifications, unpacking instructions, and identifies key features.

Assembly and Component Installation

Step-by-step guide for assembling the table saw and installing major components.

Fence, Blade, and Guard Adjustments

Instructions for assembling/adjusting the rip fence, blade, and guard systems.

Alignment and Riving Knife Setup

Covers blade alignment, fence alignment, and riving knife selection for optimal performance.

Operating the Table Saw

Operation Basics and Safety Checks

Outlines fundamental operating procedures and pre-operation safety checks.

Controls, Guards, and Ripping

Explains controls and guards, with detailed instructions for ripping operations.

Crosscutting, Mitering, and Special Cuts

Guides for performing crosscutting, mitering, bevel crosscutting, and dado cuts.

Auxiliary Fences, Push Blocks, and Dust Collection

Instructions for using auxiliary fences, push blocks, and managing dust collection.

Maintenance, Support, and Warranty

Motor, Lubrication, and Storage

Information on motor overload protection, lubrication, and proper tool storage.

Routine Maintenance and Cleaning

Procedures for regular maintenance, cleaning, and care of the table saw.

Accessories, Repairs, and Registration

Details on recommended accessories, repair services, and product registration.

Warranty Information

Outlines the terms of the limited warranty, free service, and money-back guarantee.