38
English
WARNING: Max diameter to use:
• For straight-cutters, rabbet-cutters, profile cutters, the maximum
shank diameter MUST be 8 mm, the maximum diameter MUST
be 36 mm, the maximum cutting depth MUST be 10 mm.
• For slotter cutters, the maximum shank diameter MUST be
8 mm and the maximum diameter MUST be 25 mm.
• For grooved knives, the maximum shank diameter MUST
be 8 mm, the maximum diameter MUST be 40 mm and the
maximum cutting width MUST be 4 mm.
Connecting To Power Source
CAUTION: Before connecting tool to power source, check to
see that the switch is in the “OFF” position. Also, check the power
circuit to see that it is the same as that shown on specification plate
of the tool.
Starting and Stopping the Motor (Fig. 1)
CAUTION: Before starting the tool, clear the work area of all
foreign objects. Also keep firm grip on tool to resist starting torque.
CAUTION: To avoid personal injury and/or damage to finished
work, always allow the power unit to come to a COMPLETE STOP
before putting the tool down.
To turn unit on, depress the side of the dust-protected switch (D) that
reads “ON” and corresponds to the symbol “I.” To turn the unit off,
depress the side of the switch that reads “OFF” and corresponds with
the symbol “O.”
M
N
O
P
PLUNGE BASE
AA
R
FIXED BASE
I
K
H
D-SHAPED SUBBASE
MOTOR
FIG. 1
A
E
D
F
C
B
G
U
Z
F
G
ROUND
SUBBASE
To Next Page
Loading...
Need help?
General
