DeWalt DWP611 - Using a Premium Edge Guide; Vacuum Attachment

42
English
3. Slide edge guide into edge guide slot (J) on side of fixed base or
(X) on side of the plunge base. Insert the two flat head screws
through the appropriate holes in the sub base to secure the edge
guide. Tighten hardware.
4. Follow all instructions included with the edge guide.
FIG. 7
Q
J
GG
NOTE: To remove the edge guide, reverse the above procedure. After
removing edge guide always replace the two flat head screws into the
storage holes on the edge guide to prevent loss.
Using a Premium Edge Guide
(Plunge Base Only)
A premium edge guide (model DW6913) is available from your
local retailer or service center at extra cost. Follow the assembly
instructions included with the edge guide.
FIG. 8
V
W
Vacuum Attachment
(Fixed Base Only, Fig. 8)
To connect the router to a vacuum cleaner for dust collection, follow
these steps:
1. Remove the motor unit from the base unit, see Motor Quick
Release.
2. Attach vacuum attachment accessory (V) to the base as shown.
Tighten thumb screws (W) securely by hand.
3. Attach hose adapter to vacuum attachment accessory.
4. When using vacuum attachment, be aware of the placement of
the vacuum cleaner. Be sure that the vacuum cleaner is stable
and that its hose will not interfere with the work.