19
ENGLISH
Protecting the Environment
Separate collection. Products marked with this symbol must not
be disposed of with normal householdwaste.
Products contain materials that can be recovered or recycled
reducing the demand for raw materials. Please recycle electrical
products according to local provisions. Further information is available at
www.2helpU.com.
Clamp: DW7090-XJ (Fig. B)
The clamp
37
is used for firmly clamping workpiece to the sawtable.
Quick Release Clamps: DWS5026-XJ
Dust Bag: DW7053-QZ (Fig. C)
Equipped with a zipper for easy emptying, the dust bag
38
will capture the
majority of the sawdustproduced.
Leg Stands: DE7023-XJ, DE7033-XJ (Fig. D)
The leg stand
39
is used to extend the table width of thesaw.
Clamp Brackets: DE7025-XJ (Fig. E)
The clamp brackets
40
are used for mounting the saw to astand.
SAW BLADES: ALWAYS USE 250 mm SAW BLADES WITH 30 mm ARBOUR
HOLES. SPEED RATING MUST BE AT LEAST 4000 RPM. Never use a smaller
diameter blade. It will not be guarded properly. Use crosscut blades only!
Do not use blades designed for ripping, combination blades or blades with
hook angles in excess of 5°.
BLADE DESCRIPTIONS
APPLICATION DIAMETER TEETH
Construction Saw Blades (thin kerf with anti-stick rim)
General Purpose 250 mm 40
Fine Crosscuts 250 mm 60
Woodworking Saw Blades (provide smooth, clean cuts)
Fine crosscuts 250 mm 80
Non-ferrous metals 250 mm 96
Optional Accessories
WARNING: Since accessories, other than those offered by
,
have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only
recommended accessories should be used with thisproduct.
Consult your dealer for further information on the appropriateaccessories.
To Next Page
Loading...
Need help?
General
