DeWalt DWS709 User Manual

DWS709
12" (305 mm) Double Bevel Sliding Compound Miter Saw
Scie coulissante à onglet mixte 305 mm (12 po)
Sierra ingletadora compuesta deslizante de doble bisel de 305mm (12")
INSTRUCTION MANUAL
GUIDE D’UTILISATION
MANUAL DE INSTRUCCIONES
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA DE
GARANTÍA. ADVERTENCIA: LÉASE ESTE INSTRUCTIVO ANTES DE
USAR EL PRODUCTO.
Questions? Visit us at www.dewalt.com
Des questions ? Rendez nous visite à www.dewalt.com
¿Tiene preguntas? Visítenos en www.dewalt.com
Before returning this product call
1-800-4-DEWALT
IF YOU SHOULD EXPERIENCE A PROBLEM WITH YOUR D E WALT PURCHASE,
CALL 1-800-4-DEWALT
IN MOST CASES, A D E WALT REPRESENTATIVE CAN RESOLVE
YOUR PROBLEM OVER THE PHONE.
IF YOU HAVE A SUGGESTION OR COMMENT, GIVE US A CALL.
YOUR FEEDBACK IS VITAL TO THE SUCCESS OF D
E WALT’S
QUALITY IMPROVEMENT PROGRAM.

DeWalt DWS709 Specifications

General

Brand	DeWalt
Model	DWS709
Category	Saw
Language	English

Summary

Important Safety Instructions

Double Insulation

Explains the double-layered electrical insulation for safety.

Polarized Plugs

Details the use of polarized plugs to reduce electric shock risk.

Accessories

Optional Accessories (Fig. 1)

Lists optional accessories available for the miter saw.

Changing or Installing a New Saw Blade

Features and Controls

Miter Control (Fig. 5)

Explains how to adjust the miter angle using the lock knob and latch.

Trigger Switch (Fig. 4)

Describes the operation and security features of the trigger switch.

Bevel Lock Knob (Fig. 4)

Details how to adjust and lock the bevel angle of the saw.

Cutting With Your Saw

Crosscuts

Describes how to perform straight crosscuts on the saw.

Support for Long Pieces

Cutting Crown Molding

Special Cuts

Aluminum Cutting (Fig. 17, 18)

Guidelines for safely cutting aluminum with the saw.

Special Set-up for Wide Crosscuts (Fig. 22, 23)

Procedure for cutting wide workpieces using a special setup.

Maintenance

Removing and Replacing Belt (Fig. 4, 24)

Steps for inspecting and replacing the drive belt.

Repairs

Register Online

Troubleshooting Guide

Saw will not start

Common issues and solutions when the saw fails to start.

Saw makes unsatisfactory cuts

Diagnosing and fixing problems causing poor cut quality.

Blade does not come up to speed

Reasons and fixes for the blade not reaching operating speed.

Machine vibrates excessively

Troubleshooting excessive vibration from the saw.

Does not make accurate miter cuts

Steps to correct inaccuracies in miter angle settings.

Material pinches blade

Identifying causes and solutions for blade pinching.