Need help?Do you have a question about the DeWalt DWS780-XE and is the answer not in the manual?
General| Power Input | 1800 W |
|---|---|
| Blade Diameter | 305 mm |
| Blade Bore | 30 mm |
| No-Load Speed | 3800 RPM |
| Dust Collection | Yes |
| XPS Cutline Shadow Light | Yes |
| Type | Sliding Compound Miter Saw |
| Blade Speed | 3800 RPM |
| Bevel Capacity | 49° left and right |
| Miter Capacity | 50° Left and Right |
| Cutting Capacity at 90°/90° (W x H) | 305 x 110 mm |
| Cutting Capacity at 45°/90° (W x H) | 303 x 76 mm |
| Cutting Capacity at 45°/45° | 212 x 76 mm |
| Cutting Capacity (Vertical) | 6 inch (152 mm) |
| Weight | 24.8 kg |
| Power Source | Corded |
General safety instructions for operating the product, including warnings and precautions.
General safety guidelines applicable to all tools, covering workspace, apparel, and tool use.
Specific safety rules tailored for the safe operation of miter saws.
Safety warning labels located on the motor housing of the saw.
Safety warning labels affixed to the moving fences of the saw.
Safety warning labels found on the guard and table of the saw.
Safety considerations for operation by children or infirm persons.
Instructions for replacing a damaged supply cord to avoid hazards.
Details on recommended saw blades, including specifications and types.
Lists various optional accessories such as work supports, clamps, fences, and stands.
Step-by-step instructions for safely removing the saw blade.
Step-by-step instructions for safely installing a new saw blade.
Guidelines for securely mounting the saw to a stable surface using provided holes.
Instructions on locking various parts to secure the saw for safe transport.
How to adjust and lock the mitre angle of the saw.
How to adjust and lock the bevel angle of the saw head.
Feature allowing beveling past the 0° mark and its operation.
Procedure to adjust the mitre scale for accurate angle readings.
Aligning the blade to be square with the saw table.
Adjusting the fence to provide clearance for bevel cuts.
Guidance on maintaining correct body posture and hand placement during operation.
Instructions for operating the trigger switch to turn the saw on and off.
Instructions for performing basic straight vertical crosscuts.
Procedure for making crosscuts on larger workpieces using the sliding feature.
Instructions for performing mitre cuts at various angles.
Guidance on setting and performing bevel cuts.
Using the depth stop for cutting grooves.
Making compound mitre cuts for frames and boxes using angle charts.
Instructions for cutting crown moulding with the saw table and fence.
Guidelines and precautions for cutting aluminum with the saw.
Correct positioning of bowed material for safe cutting.
Procedure for cutting plastic pipe and other round materials.
Procedure for cutting wide workpieces using a special platform setup.
Guidance on inspecting and replacing carbon brushes.
Instructions for cleaning the saw, including guards and worklight lens.
Diagnosing and fixing issues when the saw fails to start.
Troubleshooting common causes of poor cut quality.
Identifying and resolving issues with blade speed.
Addressing causes of excessive vibration during operation.
Troubleshooting and adjusting for inaccurate miter cuts.
Diagnosing and preventing material from pinching the blade.
To Next Page
