12
Starting the Engine
b.To start a cold engine, move the Choke to the CHOKE position.
To restart a warm engine, leave the Choke in the RUN position.
a.To start a cold engine, move the Choke to the CHOKE position.
To restart a warm engine, leave the Choke in the RUN position.
1. Open the Fuel Valve.
2.
For MANUAL START
a.Turn the Engine Switch to ON.
c.Grip the Starter Handle of the Engine loosely and pull it slowly
several times to allow the gasoline to flow into the Engine’s
carburetor. Then pull the Starter Handle gently until resistance
is felt.
Allow Cable to retract fully and then pull it quickly. Repeat
until the engine starts.
Note: Do not let the Starter Handle snap back against the engine.
Hold it as it recoils so it doesn't hit the engine.
3. For ELECTRIC START
d. Allow the Engine to run for several seconds. Then, if the Choke lever
is in the CHOKE position, move the Choke Lever very slowly to its RUN
position.
Note:
Moving the Choke Lever too fast could stall the engine.
To Next Page
Loading...
