EasyManua.ls Logo

DeWalt DXGNP30E - Page 22

DeWalt DXGNP30E
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
c. Allow the Engine to run for several seconds. Then, if the Choke lever
is in the CHOKE position, move the Choke Lever very slowly to its RUN
position.
Note:
Moving the Choke Lever too fast could stall the engine.
IMPORTANT: Allow the engine to run at no load for five minutes
after each start-up so that the engine can stabilize.
b.Turn the Engine Switch to START.
Note: To prolong starter life, use short starting cycles (5 seconds
maximum). Then wait one minute before attempting to start again.

Related product manuals