DeWalt Flexvolt DCV585 User Manual

9
ENGLISH
Fig. E
25 26
1717
Pairing the Dust Extractor with a Tool using
Wireless Tool Control™ Mode (Fig. A, D)

CAUTION: When the dust extractor is being controlled
with the remote or paired power tool it may start or
stop without warning.

WARNING: Do not attach the remote strap to
movingparts.
To Pair with a
DeWALT
Remote or
Wireless Tool Control™ Tool
1. Press the three position switch
3
to the Wireless Tool
Control™ ( ) position.
2. Press and hold the Wireless Tool Control™ pairing
button
11
on the DCV585 and pull the trigger on
the Wireless Tool Control™ equipped tool or press the
button on the remote
14
at the sametime.
3. The LED
19
will be steadily illuminated to indicate a
successfulpairing.
NOTE: Only one transmitter can be paired to the
DCV585 at a time. If the unit is already paired the
previous transmitter will be overridden.
To Unpair with a Wireless Tool Control Tool™ or
Remote
• Press and hold the Wireless Tool Control™ pairing
button
11
on the DCV585 and pull the trigger on
the Wireless Tool Control™ equipped tool or press the
button on the remote at the sametime.
• The LED
19
will flash slowly to indicate a
successfulunpairing.
REMOTE SPECIFICATIONS
Voltage V
DC
3
Battery life 3 Years
Signal Range <30' (10 m)
FCC ID YJ7DCV585
IC 90829-DCV585
Weight 0.60 oz (0.017 kg)
Dust Extractor Cleaning
To Empty Tank (Fig. A, F–H)
The sound of the motor changes and suction is reduced
when the tank isfull.
1. Press the three position switch
3
to the Off (O) position
and remove thebattery.
NOTE: Wait an adequate amount of time after shutting
the dust extractor off to allow dust to settle.
2. Unlatch the tank latches
4
.
Fig. F
4
3. Remove the dust extractor head
6
from thetank
16
.
Fig. G
6
16
4. Empty the contents of the tank into a suitablecontainer.
5. Clean or change HEPA filters
18
. Refer to HEPA Filter
section of thismanual.
6. Inspect machine for damage by foreign objects. Contact
the nearest
DeWALT
authorized service center for
replacement of damaged or missingparts.
7. Replace dust extractor head onto the tank.
NOTE: The dust extractor head only fits in one
orientation as shown in Fig G.
8. Latchall four latchessecurely.
NOTE: Inspect water sense probes
27
during dust

DeWalt Flexvolt DCV585 Specifications

General

Brand	DeWalt
Model	Flexvolt DCV585
Category	Vacuum Cleaner
Language	English