Need help?Do you have a question about the DeWalt Power Shop 925 and is the answer not in the manual?
Instructions for performing standard cross cuts with the machine.
Guidance on setting up and performing miter cuts at various angles.
Instructions for setting up and performing "in-rip" cuts.
Instructions for setting up and performing "out-rip" cuts.
Explains how to perform bevel cut-off operations using the machine.
Details how to execute compound miter cuts, combining bevel and miter.
Information on using the dado head for various types of dado cuts.
Instructions for using the disc sander attachment for surface finishing.
Essential 'Do' and 'Don't' guidelines for machine upkeep and safe operation.
Instructions for connecting the single phase motor to dual voltage.
Step-by-step guide for safely removing the arbor nut.
How to adjust the rip scale for 'in rip' and 'out rip' positions.
Procedure to readjust the yoke clamp handle for proper friction lock.
How to adjust the bevel clamp handle to hold the motor rigidly.
Steps to adjust rollerhead bearings for smooth arm movement.
Procedure to adjust the arm clamp handle for correct positioning.
Adjusting the base or column key gib for side motion.
Checking and adjusting table top parallelism with arm tracks.
Adjusting the blade to be perpendicular to the work top.
Aligning cross cut travel parallel to arm tracks.
List of parts for the table and frame assembly for models 925 and 1030.
Parts list for the yoke assembly, including identification numbers.
List of components for the rollerhead assembly with part numbers.
Parts identification for the arm assembly for both models.
Components list for the base and column for models 925 and 1030.
Detailed parts breakdown for single phase motors.
List of parts for poly-phase motors.
Parts for the standard guard assembly, including identification.
To Next Page
General
