Important safety information to reduce risk of fire injury.
1. Do not install within 10 feet (3 m) of a pool, spa or fountain.
2. There are no serviceable parts inside the power supply unit. DO NOT
DISASSEMBLE.
3. Do not repair or tamper with cord or plug.
4. Do not submerge transformer in water.
5. Do not mount the transformer onto combustible material.
6. Do not connect two or more transformers in parallel.
7. Do not use the transformer with a dimmer switch.
8. Plug the power supply unit directly into a GFCI wet location outlet.
9. For use with low voltage outdoor landscape lighting system only.
10. The maximum output of this transformer is 600 watts. The two zone of
this transformer have total of 600w, 300w per zone.Do not overload the
transformer. Be sure that the total cumulative wattage of all 12 volt fixtures
connected to the transformer is equal to or less than 600 watts. Each Zone
does not exceed 300w.
SAFETY INSTRUCTIONS:
The 600 Watt transformer has 600 watt circuits which will power up to 600
watts of light.Maximum 300w per zone. To make sure the maximum number
of fixtures can be safely connected to this transformer, add up the individual
wattage of all the fixtures. The total wattage of your fixtures must not exceed
output capacity of the 600 Watt transformer. Each Zone does not exceed
300w.
Being careful when splitting it.
NOT to expose the copper cable.
Remove the landscape cable
insulation 1/2 inch from both
cables and twist ends.
CALCULATION LIGHTING CAPACITY
1. Preparing the Cable
INSTALLATION
CAUTION: This landscape light system must be installed in accordance with
all local codes and ordinances. If you are experiencing problems, contact a
qualified electrician.
To Next Page
Loading...
