1. When the transformer is working, the dot in the lower right corner of the
display lights up. If the dot is not light up, it means that the transformer
has no output voltage.
2. The transformer has a power-off memory function. After the transformer
has been working in the current mode for 24 hours, the transformer will
remember the current working mode. When the transformer powers on
again, the transformer will enter the working mode before the power failure.
3. The transformer has two outputs with a total output power of 600VA.
Each zone has a maximum output power of 300w.
TIPS:
Step 1: Unplug the transformer from the power outlet.
Step 2: Check if the transformer is overloaded or not.
Step 3: Check if there is a short circuit at the transformer terminals.
Step 4: Check whether the connection between the lamp and the buried
wire is short-circuited.
Step 5: Press the circuit breaker button switch.
Step 6: After troubleshooting, replug the transformer, it will automatically reset.
TROUBLE SHOOTING
T1 The display shows "F"
Step 1: Unplug the transformer from the power outlet.
Step 2: Check if the transformer terminals are properly connected.
Step 3: Check whether the connection between the lamp and the buried
wire is correct.
Step 4: After troubleshooting, replug the transformer, it will automatically reset.
T2. In ON mode, the load lamp is off, the display shows "0"
Step 1: Unplug the transformer from the power outlet.
Step 2: Check if the transformer terminals are properly connected.
Step 3: Check whether the connection between the lamp and the buried
wire is correct.
Step 4: After troubleshooting, replug the transformer into the power outlet.
T3. In AUTO mode or COUNTDOWN mode, the load lamp does not
light, the display shows "A" or "N" (N is the selected timing time).
To Next Page
Loading...
