Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.
Declaration of conformity
This boiler complies with the following directives and standards:
• 2006/95/EC Low Voltage Directive
• 2004/108/EC Electromagnetic Compatibility Directive
• 2011/65/EC (RoHS II)
• 2009/125/EC Eco design
• (EC) No. 814/2013
And also comply with the provisions of the following European Standards:
• EN 62233:2008 + C1:2008
• EN 61000-3-2:2014
• EN 61000-3-3:2013
• EN 60335-1:2012 + AII:2014 + A13:2017
• EN 60335-2-35:2016
• EN 55014-1:2017
• EN 55014-2:2015
Environment
This device is delivered in sturdy packaging in order to avoid damage during transport.
This packaging consists mainly of recyclable materials. We request that you dispose of the
packaging accordingly for recycling.
Disposal of the appliance
Old appliances must not be disposed of in your household waste! Every
consumer is legally obliged to dispose of old appliances separately from their
household waste and to take them, for example, to a collection point in their local
communityor local district. Old electrical appliances will be accepted there free
of charge. This ensures that the old appliances are properly recycled and any
negative impacts on the environment are avoided. This is why electrical
appliances are marked with the symbol shown on the left.
Installation
The device should be installed in accordance with the drawing on the first page of the
user manual. Any other installation position may result in serious damage to the device.
Installation should take place as close as possible to a cold water connection. The product
should be protected from the effects of frost (for example in caravans, summer houses,
etc.). This device may be installed above or under the work top.
This unit should not be installed in a location where it is at risk of freezing.
This unit is not to be used with thermostatic mixing valves/taps or for
supplying a mixer tap.
●
When installing, consider any risks posed by potential leaks from the product or
pipework. Avoid installation in areas where a leak could have potentially severe
consequences, such as near electronic equipment
●
Check for potential freezing of the pipework or heater and take action if required, such
as lagging supply pipes.
●
The heater should be located as close as practical to the hot water outlet as this avoids
heat losses through the pipework and improves performance.
This system allows water to be drawn from a single discharge point. Never use a shut-off valve
in the appliance’s outlet. The connection pipes must be installed as shown in the drawing.
It is recommended that a 3 Litres per minute flow restrictor/spray head be used in the hot outlet
tap.
DXI55 INSTANT WATER HEATER
To Next Page
Loading...