EasyManua.ls Logo

dexPro DXI55 - Technical Specifications and Operation; Detailed Product Specifications; Adjusting Water Flow Rate

dexPro DXI55
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Manual
Do not switch on the device if there is a chance the water inside the device is
frozen.
Make sure the pressure of your water supply system supersedes the 0,5bar (0,05MPa).
When the power is turned on for the first time, or if the power has been switched off, the
appliance requires about 15 seconds to start up.
After this, the appliance will automatically switch on each time a water tap is opened.
The temperature of the running water appears on the display. When the tap is closed, the
display switches off after 3 seconds.
The appliance can be installed with the inlet and outlet at the top or at the bottom. If the
controls and temperature indication are displayed upside down, switch off the power
briefly. The display will correct itself when you switch on the power again. The appliance
will require about 15 seconds to start up again. If the set temperature is not reached, adjust
the water flow rate.
Adjusting the water flow rate
Step 1: Press down on the ribbed area of
the cover and move it towards the wall.
Step 2: Apply pressure to the rear of the
cover until the front lifts.
Step 3: Now remove the cover by pulling
it forwards.
Step 4: Adjust the screw to the desired
setting. Turn it clockwise for maximum water
flow. Turn it anticlockwise to reduce the
water flow.
Temperature and flow rate
Flow rate (Δt)
Rating power 2.0L/min 2.5L/min 3.0L/min
5.5kW +39.3°C +31.4°C +26.2°C
Note: Parameters in the above table are drawn under the following condition:
Voltage Supply: 230V /50Hz
Specifications
Nom. power rating 230V ~ 50Hz
Dimensions 130(h) x 186(w) x 90mm(d)
Electric supply 5.5KW
Nominal current 24A
Cable size 3x 2.5mm (not included)
Flow rate (Δt=25K) L/m 3.0L/min
Heating system unvented
Min. water resistance at 15°C ≥ 1300Ωcm
Switch on flow rate 1.6L/min.
Max. inlet temperature 30°C
Non-usage consumption <0.1Wh/h
Protection class 1
Type of protection IP24
Unit weight 1.5Kg
Water connections G³/₈"
Distance water connections 30mm
Max. pressure water mains 0.8MPa
Switch on flow pressure 0.05MPa
Daily electricity consumption 1.263 kWh
Load profile XXS
Sound power level 16dB
Energy efficiency 40.0 %
2
4
3
1
DXI55 INSTANT WATER HEATER