22
WATER CONNECTION – OPTIONAL MODEL
An uninterrupted water supply is required for models with the optional water dispensing re response
system. See the dryer dimension section for the location of the water line connection on the rear of the
dryer. The thread size on the water valve is 3/4 - 11.5 NHT. The water supply pressure should be 40-120
psi (2.8-8.2 bar). The system will spray at a rate of 6 gallons of water per minute while spraying. A ex-
ible supply line to the dryer is required to prevent damage to the water valve. It is critical to ensure that
the room temperature is kept above freezing in the area of the water pipes.
DRYER SHUTDOWN
To render the dryer inoperative, turn o the main gas shut-o valve and disconnect electrical power to the
dryer.
IT IS RECOMMENDED THAT THE INSTALLER TEST THE DRYER FOR OPERATION AND
INSTRUCT THE USER BEFORE LEAVING THE INSTALLATION.
Part # 8533-112-001 7/21
To Next Page
Loading...
Need help?
General
