Dexter Laundry C-Series - Page 38

38
B. Based on your internet browser the le needs to be saved as “AllUser.xml”. Depending
on your Internet browser you may need to retrieve the le from
your “Downloads” folder, which is located under “Computer”.
Note: The newly created programing le may have changed from the proper “AllUser.xml Ma
chine programming will not occur using a dierent le name than “AllUser.xml”. Any
extra extension names will require the le to be renamed back to “AllUser.xml” for the
machine to recognize the le.
7) To save the Programming File to a USB Drive:
A. Move or Copy the “AllUser.xml” le from your computer onto a USB drive.
B. Based on your computer and internet browser, this le may be found in your “Down
loads” folder, which is located under the “Computer” area.
Note: The “AllUser.xml” le size is small, nearly any capacity USB drive will do.
8) Program Your Machines Using the USB Drive
CAUTION!!! Be sure that any loose keys or other items that are connected to the USB de-
vice are removed from the USB stick to prevent any possible metal contact
with the control board.
A. Insert the USB drive containing the “AllUser.xml” le into the Dexter machines you
wish to program. The control will scroll “…………” while identifying the program on
the USB. Once identied, the display will scroll “INSTALL USER FILE FROM USB”. At
this prompt press the green start button on the front panel.
USB Port
8514-234-001 rev. A page 14
-Cool-down time (owner programmable) is always part of the cycle time purchased by the customer. For example,
if the cool-down time is 2 minutes, then the last 2 minutes of the cycle will have no heat.
PROGRAMMING THE DRYER CONTROL
The dryer control can be programmed to prompt the user for alternate vend prices, change dryer cycle times,
temperatures and many other options. This can be accomplished in two ways:
1. Manual programming utilizing the “Start”, “High”, “Medium” and “Low” buttons.
2. USB download of a pre-programmed User File. For instructions on using the USB download feature,
please contact your local Dexter distributor.
MANUAL PROGRAMMING:
The dryer must be in idle mode for the manual programming menus to be accessed. Idle mode is when the dryer
is not actively running a drying cycle and the vend price is displayed on the screen.
To enter the manual programming mode, the upper service door on the dryer must be unlocked and lifted to
reveal the back side of the control. The programming button is found in the location shown below. The
programming button is then pressed for 1 second. The control should display “DRYER PROGRAMMING”.
See the figure below for the location of the programming button on the dryer control. Please note, this is the
control as viewed from the underside of the lifted service door.
Program
Button
Part # 8533-088-001 7/21