Welcome to DFRobot: www.DFRobot.com.cn 13 / 49
Caution: The network barrier will lead to installation blocking. Then you should restart Addino IDE
forcefully and redo the steps before. Or you should speed up the network with proxy software to
accomplish the installation. Moreover, some key processes may be blocked by the firewall and
antivirus software. That’s why you should authorize it to change and add it to the write page.
STEP4: connect FireBeetle Board-ESP32 to your computer.
When we installed the Arduino IDE and the core center of the FireBeetle Board-ESP32 successfully,
FireBeetle Board-ESP32 can be connected to computer by USB data wire. If the operation is right,
CHG power light of the FireBeetle Board-ESP32 will flash to check whether the lithium battery has
been applied.
You reguire confirming the developing board has been recognized by the computer and which
COM has been connected (for COM to COM interaction).
The following steps will help you to confirm.
Open Control panel-> Device Manager->Ports (COM&LPT).
The COM connects to FireBeetle Board-ESP32 shown in the list as below (Here is COM3)
To Next Page
Loading...